P0228
Throttle/Pedal Position Sensor/Switch "C" Circuit High
Severesensor
Overview
The P0228 diagnostic trouble code means the PCM has identified a throttle/pedal position sensor/switch "c" circuit high problem. This code indicates that a sensor or its circuit is not providing expected readings to the engine management system. Faulty sensor data can cause the PCM to make incorrect adjustments, affecting engine performance.
Symptoms
- Engine running rough
- Poor fuel economy
- Erratic engine behavior
- Hard starting in certain conditions
Common Causes
- Sensor contamination or buildup
- Faulty sensor (out of range or failed)
- Incorrect sensor installed
- Corroded or damaged sensor connector
Diagnosis Steps
- 1Connect an OBD-II scanner and read all stored trouble codes and freeze frame data
- 2Locate the specific sensor referenced by the code
- 3Inspect the sensor connector for corrosion, damage, or loose pins
- 4Test the sensor output using a multimeter or scan tool live data
- 5Check the wiring between the sensor and the PCM for opens or shorts
Estimated Repair Cost
$75 — $350
Cost varies by vehicle, location, and repair shop. Includes parts and labor.
Commonly Affected Vehicles
Mazda 3Ford FocusToyota CorollaChevrolet Cruze
Related Codes
More Sensor Codes
P0070Ambient Air Temperature Sensor Circuit
LowP0071Ambient Air Temperature Sensor Range/Performance
LowP0072Ambient Air Temperature Sensor Circuit Low
LowP0073Ambient Air Temperature Sensor Circuit High
LowP0074Ambient Air Temperature Sensor Circuit Intermittent
LowP0095Intake Air Temperature Sensor 2 Circuit
LowFrequently Asked Questions
Most automotive sensors last 80,000-150,000 miles, though this varies by sensor type and driving conditions. Oxygen sensors and temperature sensors tend to degrade gradually over time.