OBD Codes

C0082

Brake Fluid Level Sensor Circuit High

Severesensor

Overview

The C0082 diagnostic trouble code means the chassis control module has identified a brake fluid level sensor circuit high problem. This code indicates that a chassis sensor or its circuit is not providing expected readings to the ABS/stability control system. Accurate sensor data is essential for the proper operation of anti-lock brakes, traction control, and electronic stability control, and a fault in this circuit can cause these safety systems to be disabled.

Symptoms

  • ABS activates at inappropriate times or low speeds
  • Unusual clicking or grinding noise from wheel area
  • Tire pressure warning light illuminated
  • Stability control (ESC/VSC) warning light on

Common Causes

  • Contaminated or worn brake fluid level sensor
  • Damaged wheel bearing causing sensor misalignment
  • Corroded or broken sensor wiring/connector
  • Failed yaw rate or lateral accelerometer sensor

Diagnosis Steps

  1. 1Connect an OBD-II scanner and read all stored chassis trouble codes and freeze frame data
  2. 2Monitor wheel speed sensor signals using scan tool live data while driving
  3. 3Inspect the affected sensor and its wiring connector for damage or corrosion
  4. 4Check the sensor air gap and tone ring for damage, debris, or excessive wear
  5. 5Test the sensor resistance and voltage output with a multimeter; compare to specifications

Estimated Repair Cost

$100$500

Cost varies by vehicle, location, and repair shop. Includes parts and labor.

Commonly Affected Vehicles

Subaru OutbackMazda CX-5Ford FocusToyota Corolla

Related Codes

More Sensor Codes

Frequently Asked Questions

The most common causes are a faulty sensor, damaged tone ring, excessive air gap, metallic debris on the sensor tip, corroded wiring, or a worn wheel bearing that allows the sensor to lose alignment with the tone ring.